"Spring skiing leaves behind a microscopic film of oil, grease, sap, and road salt on your equipment. If left untouched, these contaminants slowly eat away at the base material and hardware."
"Keep jet sprays away from the bindings to preserve internal factory lubricants. Ensure the entire setup is bone dry before moving forward."
"Run a fine diamond file or a specialized rubber gummy stone along the side and base edges. You aren't reshaping the edge angle; you are simply polishing away micro-rust and rough spots so the steel remains intact over the summer."
"The single most effective defense against base degradation is a heavy layer of un-scraped hot wax, which seals the base material from exposure to the air. Melt a soft, warm-weather or universal base wax onto the ski with a tuning iron, spreading it thickly from tip to tail. Leave the thick layer completely intact."
Spring skiing leaves oil, grease, sap, and road salt on ski bases and hardware. A deep clean removes surface grit and stubborn wax or soot using water and a specialized citrus base cleaner, while avoiding high-pressure spraying near bindings to protect internal lubricants. After cleaning, steel edges are inspected for nicks and rough spots from rocks. Fine diamond files or rubber gummy stones polish micro-imperfections without reshaping edge angles, reducing moisture retention and rust risk. Finally, a thick layer of un-scraped hot wax is melted onto the base from tip to tail using a tuning iron, forming a protective barrier that seals the base from air exposure and helps keep it hydrated over summer.
Read at SnowBrains
Unable to calculate read time
Collection
[
|
...
]